How To Cut A Lock Into A Door

Punch a nail or awl through the center of the template s face bore.

How to cut a lock into a door.

You usually need a 2 1 4 inch hole saw to install a lockset and a 1 inch spade bit for the barrel assembly but yours. Tilt the lock to the side so you can easily cut the side of the shackle or the metal clasp that holds the lock together. How to cut a mortise for a deadbolt lock. Measure and mark a line along the center side to side of the jamb strip intersecting the line made in.

Mark the precise center top to bottom of the bolt. Mark the area around the strike plate that you want to install flush with the wood. Tools needed for this job. Make a cut out for the strike plate make a cut out of about 3 mm deep into which the strike plate fits neatly.

This marks the center of the face bore on the door. Measure the thickness of your door before starting and use the marks supplied on the template for a door of that. How to chisel out a door lock plate. Be careful not to cut deeper than the hinge thickness.

This video is about how to fit a door latch and door handle in an interior door. Using a router attachment remove the wood between the pencil lines drawn on the door edge to create a mortise for the. Lightly tap the chisel with a hammer to remove the waste between each of the cut lines inside the mortise. Pull the handles apart so the blades open.

Wrap the cardboard template supplied with the lockset around the door s edge. Hold the chisel at a low angle to the door parallel to the door s length with the flat side of the chisel against the wood. Make a series of. Align its centerline with the line drawn in step 2.

5 unscrew template from door. The outer face of the strike plate should be flush with the edge of the door frame. Put the lock s shackle between the blades of the bolt cutters. Use the chisel to deepen the outline marks.

Hold the bolt cutters in a comfortable position near your waist. 6 set latch into hole and mark its outline on door edge. Fit the latch and faceplate into the door. Tape measure pencil flat drill bit for wo.

Do the same to the template s edge bore to mark the center of the edge bore on the door. Use a bevel edge chisel and hammer to square the corners of the mortise if the faceplate has square corners. Make a series of closely spaced cuts into the mortise area. Close the door and look for where the lock bolt or latch bolt contacts the doorjamb.

4 use a 1 inch hole saw to bore latch hole in door edge.