How To Do Valleys Metal Roofing

Best practices for sealing the metal roof valley vary based on the slope of the roof.

How to do valleys metal roofing.

Cut corners and apply cement dub cut the top layer shingles see step 4 in open metal valley above. Apply two beads of roofing cement to attach the top layer shingles to the bottom layer shingles. Then starting at the base of the. Use fasteners to attach the panel to the structure making sure that there is complete compression of the sealant.

First clean the debris out of the valley including sawdust nails and whatever else is in there. Ensure ice and water protector has been installed along the valley first. Fold the top over the roof ridge and cut the bottom along the drip edge metal. Many roofers cut the shingles across because they say it s safer.

Install synthetic roofing. In this video i show you how i do the valleys on a shingle roof. No one of this affirmat. Cut each side of the flashing at the lower end to conform with the corresponding edges of the roof using sheet metal cutters.

Only nail at the edges with only enough nails to. Cut each side at the upper end of the valley to conform with the. With a clean valley you can lay down some peel and stick roofing membrane. How to seal metal roof valley.