How To Fit A Roof Vent

Install shingles as normal up to the base of the plumbing vent.

How to fit a roof vent.

Place all the roof vents on the same side of the roof. Place the flashing or boot onto the plumbing vent so the base is resting on shingles. You should be able to see the attic interior when done. To install the vent the roofer slips the flange the metal lip of the vent under shingles at the upper part of the hole and rests the flange on top of the shingles at the down slope part of the hole.

Record those measurements on a notepad. Locate the drill bit. If you are installing the roof vent in a place where there are ridges and uneven surfaces we recommend a roof vent adapter to make the installation process easier. Installing a roof plumbing vent is typically an easier task than flashing a chimney.

Space attic vents evenly and mark the locations by driving nails up through the shingles photo 1. Allow space for the edge of the vent opening where it will rest on the roof. To install a roof adaptor cut and clean the hole in the roof as you would normally. If your roof peak runs parallel to the street put them on the backside where they ll be less prominent.

Using the tape measure determine the size of the cut into the roof that will be necessary to insert the vent into the space. Measure the body of the vent. Drill a hole upward through the middle of the area you desire and leave the drill bit sticking up through the roof so you can find it from the outside. Center the vents on the peak of your roof so the sides of the vent lay flat on the roof.

Here is how you do it. Momentarily lift the boot and apply sealant to hold the flashing in place. Use enough vent pieces to fill the length of the slot you cut. Remember to allow for the lip on the vent mechanism that will fit over the opening and rest on the surface of the roof.

Then cover the bottom of the adaptor with 3m marine sealant and clamp it to the roof until dry. First head up to your attic and determine where you want to install your roof vent. Apply a layer of sealant to the edges of the hole then place the vent into position. Mark the outline of the roof cuts that will be needed then use a skill saw to cut the outlined space.

Plenty more videos t. If you need to cut the vent to fit at the end of your roof use a utility knife to make it flush with your home.