How To Fix Old Garage Door Spring

Snap a locking pliers onto the torsion tube to lock it into place while you tighten the drums.

How to fix old garage door spring.

Use locking pliers or a c clamp to secure the door to the track to keep it from opening when you release the tension on the springs 1 x research sourcestep 2 loosen the set screws while holding each spring with a winding bar. Diy garage door repair and save money. Rotate the drum to wind the cable into the winding grooves. If it was opening too quickly move it to the next lower hole.

Pull the cable as tight as possible before tightening the setscrews. If your garage door cable is at an angle or l. Position a sturdy ladder to the side of the springs rather than working directly in front of them for safety reasons. Retest the door balance as you did in step 1.

Leave the locking pliers in place and repeat the tightening procedure on the other side. This video is to inform you of a type of spring and bracket that exists on one piece garage doors with a jam pivot style design. Test the spring by lifting the door about 3 feet. Install the new spring reinstall the pulley and reconnect the safety cable and you re done.

Put on eye. Lubricate the spring with garage door lubricant then remove the clamp from the garage door. Open the door to relieve the spring tension and secure it open with c clamps in the tracks. If the door remains in place the replacement was a.

This video will show you how to repair a mis aligned garage door cable. This system is unsafe and sh. Once the spring is free of tension remove from its track hanger. The general process is simple and safe.

If the door was closing too quickly move the spring to the next higher hole on the bracket. Adjust the springs on both sides of the door the same way.